To Next PageTo Next PageWhat to do if ProForm 520 turns off during use?
If your ProForm Treadmill's power turns off during use, first check the circuit breaker located on the treadmill frame near the power cord. If tripped, wait five minutes, then press the switch back in. Ensure the power cord is securely plugged in; if so, unplug it, wait five minutes, and plug it back in. Also, remove and re-insert the key fully into the console.
What to do if ProForm 520 Treadmill incline does not work?
If the incline of your ProForm Treadmill does not change correctly, insert the key into the console and press one of the Incline buttons. While the incline is changing, remove the key. After a few seconds, re-insert the key. The treadmill will automatically rise to the maximum incline level and then return to the minimum level. This will recalibrate the incline.
How to fix ProForm 520 walking belt that slips?
To address a walking belt that is off-center or slips on your ProForm Treadmill, first remove the key and unplug the power cord. If the belt has shifted left, turn the left rear roller bolt clockwise 1/2 turn; if it has shifted right, turn it counterclockwise 1/2 turn. If the belt slips, turn both rear roller bolts clockwise 1/4 turn. Ensure you can lift each side of the belt 3-4 inches off the platform without overtightening. Plug in the power cord, insert the key, and test for a few minutes, repeating adjustments as needed.
Why does ProForm 520 walking belt slow down?
If the walking belt on your ProForm Treadmill slows down when you walk on it, use only a single-outlet surge suppressor. If the walking belt is overtightened, remove the key and unplug the power cord. Then, use an Allen wrench to turn both rear roller adjustment bolts counterclockwise 1/4 of a turn. When properly tightened, you should be able to lift each side of the walking belt 3 to 4 inches off the walking platform. Keep the walking belt centered. Plug the power cord back in, insert the key, and run the treadmill for a few minutes. Repeat until the walking belt is properly tightened.
How to fix ProForm 520 speed display?
If the speed display on your ProForm Treadmill console isn't working, remove the key and unplug the power cord. Locate the Reed Switch and the Magnet on the left side of the Pulley. Turn the Pulley until the Magnet aligns with the Reed Switch, adjust the Reed Switch slightly, and retighten the screw. Re-attach the hood and test the treadmill for a few minutes to check the speed reading.
How to clean ProForm 520 Treadmill pulse sensor?
To ensure the thumb pulse sensor on your ProForm Treadmill functions properly, wash your hands before using it. Additionally, clean the pulse sensor regularly with a damp cloth and a small amount of mild detergent.
General| Weight Capacity | 300 lbs |
|---|---|
| Workout Programs | 18 built-in programs |
| Heart Rate Monitoring | EKG Grip Pulse |
| Folding | Yes |
| Cushioning | ProShox Cushioning |
| Motor | 2.5 CHP Mach Z™ Motor |
