21
Inspect and tighten all parts of the elliptical exerciser
regularly. Replace any worn parts immediately.
To clean the elliptical exerciser, use a damp cloth and
a small amount of mild soap. Important: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
BATTERY REPLACEMENT
If the console displays become dim, the batteries
should be replaced; most console problems are the
result of low batteries. See assembly step 5 on page
7 for replacement instructions.
HOW TO LEVEL THE ELLIPTICAL EXERCISER
If the the ellipti-
cal exerciser
rocks slightly on
your floor during
use, turn one or
both of the
Levelling feet
beneath the rear
stabiliser until
the rocking
motion is eliminated.
HANDGRIP PULSE SENSOR TROUBLESHOOTING
•
Avoid moving your hands while using the handgrip
pulse sensor. Excessive movement may interfere
with heart rate readings.
• Do not hold the metal contacts too tightly; doing so
may interfere with heart rate readings.
• For the most accurate heart rate reading, hold the
metal contacts for about 30 seconds.
• For optimal performance of the handgrip pulse sen-
sor, keep the metal contacts clean. The contacts
can be cleaned with a soft cloth—
never use alco-
hol, abrasives, or chemicals.
MAINTENANCE AND TROUBLESHOOTING
Levelling
Feet
To Next Page
Loading...
Need help?
General
