TROUBLE-SHOOTING
Most treadmill problems can be solved by following the simple steps below. Find the symptom that
applies, and follow the steps listed. If further assistance Is needed, call our toll-free HELPLINE at
1-800-736-6879, Monday through Saturday, 7 a.m. until 7 p.m. Central Time (excluding holidays).
PROBLEM: The power does not turn on
SOLUTION: a. Make surethat the power cord ispluggedinto a surge suppressor,and that the surge suppressor
isplugged intoa properlygroundedoutlet(see page 7). Use only a single-outletsurge suppressor
that is UL 1449 listedas a transientvoltage surge suppressor(TVSS). The surge suppressor
musthave a UL suppressedvoltage ratingof400 volts or lessand a minimumsurgedissipation
of450 joules. The surgesuppressormust be electricallyrated for 120 voltsAC and 15 amps.
Important:The treadmill is not compatiblewithGFCI-equipped outlets.
b. Afterthe power cordhas been pluggedin, make sure that the key is fully insertedintothe con-
sole. See step 1 on page 10.
c.Check the circuitbreaker locatedon the treadmill
near the power cord. If the switchprotrudes as
shown,the circuitbreakerhas tripped.To resetthe
cimuitbreaker, wait for five minutes and then press
the switchback in.
d. Check the on/off switchlocated on the treadmill
near the power cord. The switchmustbe in theon
position.
C
Tripped ,,_ Reset
Tripped Reset
On
Position
PROBLEM: The power turns off during use
SOLUTION: a. Check the circuitbreaker located on the treadmillframe near the power cord (see 1. c. above). If
the circuitbreaker has tripped,wait for five minutesand then pressthe switchback in.
b. Make sure thatthe power cord isplugged in.
c. Remove the key from the console. Reinsertthe key fullyintothe console. See step I on page 10.
d. Make sure that the on/off switch is in the on position.
e. Ifthe treadmillstillwill not run, please call ourtoll-freeHELPLINE.
PROBLEM: The speed display on the console does not function properly
SOLUTION: a. Remove the key from the console and unplug the
power cord. Remove the screwsfrom the hoodand
carefullyremove the hood.Locatethe Reed Switch
(21) and the Magnet (43) on the leftside ofthe Pulley
(42). Turn the Pulley untilthe Magnet is aligned with
the Reed Switch. Make sure that the gap between
the Magnet and the Reed Switch is about 1/8". If
necessary, loosenthe Reed SwitchScrew (76) and
move the Reed Switch slightly.Retightenthe Screw.
Re-attach the hood, and run the treadmill for a few
minutestocheck for a correctspeed reading.
/ 76 "-'_"
Vle l
20
To Next Page
Loading...
