To Next Page

To Previous Page

7. _Insertthe Iowei.end oFthe LeEArm (15} intothelee

: side of the h_ment Ann (74). Make sure that the

bracket on the end of the LeftArm is positionedas

! shown in the inset drawing. If the bracket is"_ot

i positioned as shown,, the LeftArm will not f_nction

proper_y.

Tap-a 3/4" PlasticCap (57) ontoone oFt_ endsoF

a 3/4' x 4" J_e (54). Align thehole in the end oF

the Left_ (15} with the holesin the MomentAnn

:(74). Insert the AxJeinto the Momenb_-m and the

LeftArm. Tea a 3/4" PlasticCaa onto theAxle.

•Note: An exlTa 3/4' PlasticCap (57) hc_ibee'-h_: -

included with the hardware Pock. If you accldentol.

_ly damage one of the PlasticCapsduring assem-

bly, use the extra Plastic Cap. Othenvlse, the exh'a

•PlasticCap may be discarded.

:,_.tochtheRightArn'l(i6) inthesamemanner.

Wrap theWeight Cable (52) under th_ 3 1/2=!

Pu ey (5) on the lower end of theUpright (9). Make

.'surethat the Cable is belween _ Cable Tr,_p(67)

_nd thePulley.Tightenthe 3/8 I_ock Nut (6)

altachlng the Pulleyto the Upright.Make_ure Ihat

the Cable Trao is in _a _'7 "

_'ck_k" ,_osltlon.

I.ay theWeight Cable (52) over a 3 1/2' Pulley(5).

_ach a Cable Tra_ (67) and thehlley to theleft

_ide oEtheuprighi (9) with a 3/8 x 1 3/4 Bolt

(40) and 3/8" F._k N_ (6). Make sure that the

Cable Trap is in the "12 o'clock" Position.

Wrap theWelght Cable (52)a_bUh'da-2_' PUl]_(4). :

_ttach the Pulleyto the Left'Arm(15) wit\hla 3/8" x

1 3/4" Bolt{40) and 3/8" N_4ockNut 16|.

9. Wrap the Weight Cable (52) around a _3/4"

Pulle); (13). Attach the Pulley tothe indicated b?acket

ontheup ght(g) 3/8-.x13/4" lt 4_oj.

and 318" Nvln_.k N,_ I._,1_:'_" _ "

_, I l'="i /='1 .

ProForm CROSSTRAINER User Manual

Other manuals for ProForm CROSSTRAINER