Need help?Do you have a question about the Project EV EVA-07S and is the answer not in the manual?
General| Model | EVA-07S |
|---|---|
| Category | Battery Charger |
| Connector Type | Type 2 |
| Input Voltage | 230V AC |
| IP Rating | IP65 |
| Rated Current | 32A |
| Rated Voltage | 230V |
| IK Rating | IK08 |
| Protocols | OCPP 1.6 |
| RFID | Yes |
| Ethernet | Yes |
| WiFi | Yes |
| 4G | No |
| Over Current Protection | Yes |
| Over Voltage Protection | Yes |
| Under Voltage Protection | Yes |
| Residual Current Protection | Yes |
| Surge Protection | Yes |
| Cable Length | 5 m |
| Mounting Type | Wall |
| Installation | Wall-mounted |
Combines protection, system design, and user interface features for efficient operation.
Covers communication options, billing functions, and resistance to harsh environments.
Highlights the compact and exquisite exterior design suitable for various locations.
Explains the initial standby interface and how to start charging using a card.
Describes the display during charging and how to stop the session by swiping the card again.
Explains charging completion scenarios and the display for fault notifications.
Explains the meaning of DIP switch settings for network connection and charger case type.
Provides step-by-step instructions for setting the PC's IP address and accessing the charger's parameter setting page via a web browser.
Details drilling wall holes and inserting expansion bolts as the initial mounting steps.
Explains how to mount and secure the bracket and cable holder to the wall.
Describes drilling ground holes and inserting expansion bolts for pole mounting base.
Lists specific fault codes, their descriptions, and recommended solutions for troubleshooting.
To Next Page
