Need help?Do you have a question about the Projecta IC5000 and is the answer not in the manual?
General| Output Current | 5A |
|---|---|
| Charge Rate | 5A |
| Output Voltage | 12V DC |
| Battery Type | Lead Acid (Wet, MF, AGM, Gel) |
| Input | 240V AC, 50Hz |
Essential warnings and precautions for safe operation of the battery charger.
Rejuvenates sulphated batteries using high-frequency pulses.
Delivers maximum charge at constant current until set voltage is reached.
Charges battery to 100% by adjusting charge rate for maximum power absorption.
Specific charge mode for GEL batteries with a max voltage of 14.1V.
Specific charge mode for AGM batteries with a max voltage of 14.4V.
Charge mode for WET batteries with max voltages up to 16V.
Mode for Calcium batteries requiring equalisation and up to 16V.
Procedure to check and top up battery electrolyte levels.
Steps for connecting the charger to a battery outside a vehicle.
Instructions for connecting the charger to a battery within a vehicle.
Guide for hardwiring the charger leads for permanent installation.
Instructions for connecting the charger to the 240V mains power supply.
Guide to selecting the appropriate charge rate based on battery size.
Instructions for selecting the correct battery chemistry profile.
To Next Page
