english
19
After setting-up, switch on all equipment. The projector can be controlled by the keypad,
by the remote control or using the RS232 or LAN interfaces. To switch the projector on,
firmly press the POWER button on the keypad or the remote control. The STATUS
indicator will turn from yellow to blue when the unit is switched on.
If the STATUS indicator is flashing yellow, please wait until it turns permanent yellow.
Issue the PIN code if activated.
When only one source is connected, the projector will auto-detect that source. If more
sources are connected, the projector will search for the next active source according to
the following list, provided that SOURCE SCAN is set to ON in the SET UP sub menu
(see description of menu system):
- VGA
- DVI-D
- YPbPr (Component)
- S-Video
- C-Video
Select between the sources by pressing the SRC buttons on the keypad or the direct
source selection keys on the remote control. Only sources that are active will be
displayed.
If no source is active, searching messages will appear on the screen. If no source is
active for a long time, the projector will go in standby mode if DPMS (power save) is set
to ON in the SET UP sub menu.
The STATUS indicator will turn from blue to flashing yellow, then yellow. The projector
will be switched back on if at least one source is (re)activated. The power-down function
can be disabled in the menu.
See DPMS in the SET UP sub menu.
To switch the projector off, firmly press the POWER button on the keypad or the remote
control twice (to confirm that you really want to switch off the unit). The STATUS indicator
will turn from blue to flashing yellow, then yellow when switched off. You may not switch
the unit on while the STATUS indicator is flashing yellow. Please wait until the indicator
is permanent yellow.
MOUSE EMULATION – PRESENTATION CONTROL
You may use the remote control arrow keys and LEFT and RIGHT buttons as a remote
mouse, controlling your presentations and for moving the mouse pointer around on the
screen. The arrow keys allow for limited mouse pointer control.
To activate the mouse control function, you need to connect the projector to the PC via
the USB port.
USING THE PROJECTOR
M
To Next Page
Loading...
