english
32
The INDICATOR on the keypad will turn red when lamp life expires. Change the lamp
when lifetime expires. Always replace lamp with the same type and rating.
Always disconnect the power cord and wait until the projector has cooled down (60
minutes) before opening the lamp cover.
WARNING
Be careful not to touch the protective glass when replacing the lamp house, this may
cause the protective glass to overheat and break while in use.
WARNING
Be extremely careful when removing the lamp module. In the unlikely event that the
bulb ruptures, small glass fragments may come loose. The lamp module is designed to
contain these fragments, but use caution when removing the lamp module.
A
Release the front cover screw.
B
Remove the front cover.
C
Un-screw the three mounting screws.
D
Release the handle and pull the lamp out.
Replace with a new lamp in reverse order.
E
Insert a new lamp. Observe the guide pins.
F Fix the three mounting screws firmly. Do not use excess
force.
G
Re-position the handle.
H
Replace the front cover.
I Fix the front cover screw carefully, but do not use excess
force.
R
LAMP CHANGE
A
B
I
H
F
E
D
C
G
To Next Page
Loading...
