Pronto M61 - Reaching and Bending Backward Safety

SECTION 3—SAFETY/HANDLING OF WHEELCHAIRS
Part No. 1139640 23 Pronto® M61™with SureStep®
Reaching and Bending - Backward
 WARNING
DO NOT lean over the top of the back upholstery. This will change your center of
gravity and may cause you to tip over.
NOTE: For this procedure, refer to FIGURE 3.7.
Position wheelchair as close as possible to the desired object. Point the front AND rear
casters rearward to create the longest possible wheelbase. Reach back only as far as your
arm will extend without changing your sitting position.
FIGURE 3.7 Reaching and Bending - Backward