Motion Detection
First, press REC/OK button to stop recording; Second, short press Down button
to activate the Motion Detection function(the default setting is Off), the motion
detection icon appears on the third icon positon on the left side of the
screen, then standby for detection, it will recording automatically once the dash
cam detects any motion in front of the lens, 5 second is a segment.
The dash cam will start next 5 second recording if any motion is detected, keep not to
detect any motion and light before lens, then press down button can exit from the
motion detection mode and the icon will disappear from the screen.
NOTES:
1. When the battery is fully charged and is in good condition, the dash cam can
record continuously for about 50 minutes.
2. As the dash cam is used, the battery storage capacity will decrease gradually.
G-sensor Collision Recording Protection
(Protect Level)
When a collision is detected while recording, the lock icon will appear on
the upper side of the screen and the current video segment will be protected
automatically and cannot be replaced.
Audio On / Off
During recording, press power button to turn the microphone on and off.
09
PC 105 HD Dash Cam
NOTES: 1. The default setting is Low.
2. If the collision happened and you wish to protect the following videos,
you can also press menu button to acctivate the SOS function during
recording.
To Next Page
Loading...
