P.4
User Guide
WindshieldWipers,Radio&Headlights
Certain vehicles require the radio and / or windshield wipers and / or headlights circuits to become
energized while running under remote start. When leaving the vehicle you must ensure that the
windshield wipers and headlights switches are OFF. Leaving the headlights switch ON on certain
types of vehicles could cause them to remain ON even after remote starter shutdown, resulting in
a dead battery.
Remote-Starting Your Vehicle
SettingYourVehicleintoReadyMode
If your vehicle has a manual transmission you must read the following indications. The unit must
first be set to Ready Mode in order to start the vehicle by remote. If the unit is not set to Ready
Mode, it cannot remote start the vehicle.
Please note that Ready Mode can be enabled by the remote or the handbrake, depending on the
option that was selected by your installer. Therefore, you must follow the appropriate procedure
between the two described below in order to set your vehicle into Ready Mode.
Once the system is set to Ready Mode, the vehicle can be remote started and stopped at any
time. The system will exit Ready Mode if a door, the hood or the trunk is opened, if the brake pedal
is pressed, if the parking brake is disengaged or if the ignition key is turned to the IGNITION ON
(RUN) position.
To set the system to Ready Mode:
If Ready Mode is enabled by remote If Ready Mode is enabled by handbrake
1. Ensure that all the doors, hood and trunk are closed. Make sure that the gear selector is in
the neutral position.
2. With the engine already running, apply
the parking brake once and release the
brake pedal.
Make sure to release the brake pedal.
2. With the engine already running, apply
the parking brake twice and release the
brake pedal.
Make sure to release the brake pedal.
The parking lights will flash 3 times
quickly and remain lit.
Skip to step 4.
3. Within 20 sec. of engaging the parking
brake, press and hold on the
transmitter.
The parking lights will flash 3 times
quickly and remain lit.
4. Remove the key: the engine will continue running.
5. Exit the vehicle and close all doors, hood and trunk.
6. Press . The parking lights will flash 3 times to confirm ready mode activation.
7. The parking lights will flash 2 times to confirm ready mode activation.
Remotestarting
Press the button for approximately 1 second. The parking lights will come ON to inform you
that the Remote Car Starter has received your signal. Approximately 5 seconds later, the engine
will start. The parking lights will remain ON during the pre-programmed run time of the engine.
To Next Page
Loading...
