ProStart CT-3271 - Panic Mode; Quick Lockout TM

P.8
User Guide
• Press and hold the
button for at least 3 seconds until the parking lights will flash
for 2 seconds, pause, and then flash three (3) times.
OR
• If
was programmed as LOCK & UNLOCK by your installer, press and hold the
button for at least 3 seconds until the parking lights will flash for 2 seconds,
pause, and then flash three (3) times.
To exit Cold Weather Mode, do any one of the following actions:
• Open the hood.
• Start the engine by remote.
• Turn the ignition key to the IGNITION ON (RUN) position.
• Press and hold the
button until the parking lights come ON for 2 seconds, pause,
then flash once.
OR
• If
was programmed as LOCK & UNLOCK by your installer, press and hold the
button until the parking lights come ON for 2 seconds, pause, then flash once.
To verify whether the system is in Cold Weather Mode (automatic transmissions only):
• Press the brake pedal:
• If the vehicle is in cold weather mode, the parking lights will remain ON while the brake
pedal is pressed.
PanicMode
Note: Panic mode can only be activated if the horn has been adequately configured by your
installer.
In an emergency situation, you can activate panic mode by pressing and holding the for
more than 3 seconds, until the horn starts honking. If the vehicle is under a remote start, the
engine will shutdown automatically before setting off the horn. You can stop the horn by pressing
Furthermore, the panic mode can also be stopped by activating Valet Mode (page-7)
Panic Mode will automatically shut down after 30 sec.
QuickLockout
TM

(Also called Secure Panic.) For fast protection in emergency situations, the system will LOCK all
doors when you press the brake pedal while you hear the sound signal. (Quick Lockout is only
available when panic mode has been set off.)