User guide P.5
If your vehicle has an automatic transmission and it does not start at the first attempt, the system
will shut down, wait a few seconds and try to start the engine again. There will be 3 start attempts
before the system gives up.
DrivingOff
With the vehicle running under remote start, press the to disarm the security system (ONLY
if
is programmed as LOCK or UNLOCK button). Enter the vehicle and do the following:
1. Turn the ignition key to the IGNITION ON (RUN) position. (Do not turn the key to the
CRANK position while the engine is running. This will cause the starter motor to re-engage.)
2. Press the brake pedal to disengage the remote starter unit.
You are now ready to drive off.
The Starter Kill and Anti-grind feature
This added security feature will prevent the vehicle from starting with the Ignition key when the
starter kill is armed. If the system was installed with the starter kill option, you will not be able to
start the vehicle with the key unless the system has been unlocked first or put into Valet mode
(page-7)
Note: If the Starter Kill is installed, the vehicle will benefit from a protection against starter
motor damage that could occur after remote-starting the engine should the user, by force of
habit, turn the ignition key to the CRANK position.
Arminganddisarmingthestarterkill
The Starter Kill (if installed) can be configured by the installer either to Passive Mode (so as to
arm automatically) or Active Mode (so as to require the user’s intervention for arming). By default,
the Remote Car Starter is configured to Passive Mode.
Note: This feature is only available if button is configured as LOCK or UNLOCK
function.
1) Passive mode:
a) To arm the Starter Kill, press the
button on the transmitter, OR
i) In Passive Mode, the Starter Kill will also arm automatically 1 minute after the
ignition is turned OFF or once the last door is closed (if the doors are monitored).
ii) The LED on the antenna will remain OFF during the countdown preceding the
activation of the Starter Kill.
iii) Once the activation countdown expires, the LED will flash slowly to indicate that
the Starter Kill is now armed.
b) To disarm the Starter Kill, press the
button on the transmitter.
i) The Starter Kill will automatically rearm itself after 1 minute if no door is left
opened (if the doors are monitored) and the ignition is not turned ON.
To Next Page
Loading...
