ProTec Polymer Processing GmbH Foerdergeraet_FG201-FG206_BA_1v0_2018_en
6
1 Introduction
1.1 The FG 20x conveyor
1.1.1 Intended use
The FG 20x is a plastic granulate conveyor designed for industrial use. Its exclusive use is for
the conveying of free-flowing plastic granulate or mill stock. Any use deviating from this is not
intended use and must have a written approval from ProTec Polymer Processing GmbH. For
uncertainties in the use of your mill stock or in the operation of your conveyor please contact
ProTec Polymer Processing GmbH customer service.
1.1.1 Improper use
Conveying ignitable or metallic substances.
Conveying liquid materials.
Loads above the rating limits in terms of operating time and volume.
Use in explosion-endangered areas or in open air.
1.2 About this Manual
This operating manual should make it easier for you to learn about the system and its proper
use.
The operating manual contains important information about operating the system safely and
properly. Your compliance helps:
Hazards to avoid.
Reducing downtimes.
Increasing the reliability and lifetime.
The operating manual must be read and used by any person that is authorized to work with or
on the system and must be available and easily accessible to these persons, especially for:
Operation (including fitting, troubleshooting and error removal during work sequences,
removing production waste, care, disposal of operating and auxiliary materials).
Maintenance (maintenance, inspection, service).
To Next Page
Loading...