RDM0012 Issue 1 AA Page 18 of 35 © Protec Fire Detection PLC 2017
4.0 Installation Guide
The device may be surface or flush mounted (no extra bezel is required when flush mounting).
The 6000/LOOP/REPEATER front panel is fully enclosed within a sealed housing. This housing must
never be opened. If the device requires repair it must be returned to Protec.
This equipment is not guaranteed unless installed and commissioned by a suitably trained
person in accordance with current national standards.
The device must be located internally in an area that is not subject to dampness, direct
sunlight, extremes of temperature or physical abuse.
4.1 Packaging Contents
1x 6000/LOOP/REPEATER Device
3x No.8-10-12 Wall Plugs
3x No.8 x 1.5" Round Head Pozi-Drive Woodscrews
2x Opening Tools
2x 2.2mm x 10mm Pan-Head T6 Plas Tech Locking Screws
To Next Page
Loading...
