Protec PLM-8000 - Operating Panel Overview

PLM-8000 Operation Manual
10
4.4 Operating panel
4.4.1 Basic operation
Basic operation of the PLM-8000 is performed on the touch panel.
4.4.2 Measurement display
(1) Measured data
Indicates the following data:
 S : Spherical value
 C : Cylinder value
 A : Angle of cylinder shaft
 P : Prism value
 ADD : Progressive ADD value
 RPD, LPD : PD value
(2) Concentric circle of prism
Concentric circles indicates 1 Prism~7Prism respectively.
(3) Measured lens
Indicates whether the lens being measured is a monocle or a right-side/left-side lens.
(4) Cylinder mark
Cylinder mark is indicated as ‘+’, ‘-‘ according to ‘CYLINDER’ of user menu.
(5) Measurement step
Display step of 0.01, 0.06, 0.12, or 0.25.
(6) Auto Measurement
Display whether the measurement is used automatically or manually.
Patient ID
Measurement unit
Measured lens
Lens Type
Measured lens
Cylinder
Auto
Measurement
Measured data
Concentric
Circle of prism
Target(Cusor)
Touch menu button
Zoom
PD/OH Mode