Protelex ICM-X22 - Parameter Setting of Ice Cream Machine

www.nkprotelex.com
13
overtime
failure
2.Maintenance refrigeration
system
09
over-current
protection
1. Motor fault exists
2.Hardness grade is high，so
that ice cream is too hard
and cause jam mixer
1. Replace the motor; or adjust
the motor belt tightness;
2.Adjust the appropriate
hardness grade
No electricity
no display
after connect
power
1. Power plug is not good。
2. The motherboard
connection is not good
3. Insurance tube bad
4. Circuit board fault
1. Check the power supply if is
normal
2. To connect the display screen
and the mainboard of
connection
3. Eliminate abnormal after
replacement of the same
specifications of the insurance
tube
4. Repair PCB repair PCB must
be conducted by professionals
Machine stop after plug: check liquid has entered inside the air pump. Disconnect the air
pump from the pc board
9. Parameter Setting of Ice Cream Machine
Parameters are divided into user parameters and plant parameters.
User parameters: long press the set button or stop button to enter the user parameters.
Factory parameters: Long press the set button and stop button at the same time to enter
the factory parameters.
Paramet
er code
Parameter
type
Definition
Note
Parameter
setting
Harder /
Softer
button
User
parameters
Ice cream hardness
Normal display, press
harder or softer button.
Adjustable range: 02-05
02
n00
User
parameters
Pre cooling
temperature
Pre cooling is enabled,
the temperature of the
pre cooling can be
adjusted between 4 and
10.
04
n01
User
parameters
Clear number
Reset counter
Press harder and softer
button 6 seconds at the
same time can cleaning
up ice cream number,