START-UP PROCEDURE
NOTE:
1. If after 30 seconds, it has not recognized the drone, turn off the controller
and repeat Start-Up procedure.
Before flying, the drone and transmitter must be turned on in sequence
and synchronized.
1. Turn on the drone by pressing the on button and holding for 3 seconds. The
lights on the drone will flash to indicate it’s on. Place it on an even surface.
The blue lights on the drone are at the front and the red are at the back.
2. Turn on the remote control.
3. The remote will beep several times. Push the throttle up and then down to
sync the drone. The remote will beep once and the lights will go steady to
indicate it has synced.
4. Your drone is now synchronized, and in stand-by mode awaiting Engine
Idle command.
STARTING THE ENGINE; ENGINE IDLE
After synchronizing the drone, hit the START button (X) to go into idle mode.
The blades will rotate but the drone will not lift.
*The engines will shut off automatically after 10 seconds if the pilot does
not take off.
6
To Next Page
Loading...
Need help?
General
