Page 42 of 126
Proton Products SL mini and SLR mini Series Speed and Length Gauges Instruction Manual - issue 1s
Configure the WIFI interface as required then click the “Apply” button when complete.
Switch on the WIFI function.
Switch off the WIFI function.
The gauge acts as a client device in client mode.
The gauge acts as an access point in AP mode.
Select the region where the gauge is located.
Select the radio channel for the gauge.
Select the network encryption method.
Enter the SSID of the network.
Enter the password of the network.
Select this option to enable the gauge to automatically
acquire its IP address, subnet mask and gateway from a
DHCP server on the network.
Select this option to manually configure the gauge IP
Address, subnet mask and gateway in the fields below.
Enter the IP address assigned to the gauge.
Enter the subnet mask for the network.
Enter the gateway IP address for the network.
Enter the physical MAC address of the WIFI chip.
* [ ] indicates factory-default values.
Note: To restore the gauge to factory-default network settings, click the “Default” button. See the
table above for the factory-default values.
To Next Page
Loading...