Electric Floor Model
7
Section Header
Mode Select
ProDigital™ can either be used as a thermostat or a time clock. Thermostat mode
is the default setting.
To change between thermostat & time clock modes, follow these steps.
• Use the ‘Left/Right’ arrow keys to highlight then press and hold
the button for 3 seconds ..........................................................................................
At this point the screen will go blank showing only ‘SETUP’ and ‘CLOCK’.
• Tap either of the ‘Up’ or ‘Down’ arrow keys to highlight ‘SETUP’, then hold
the
key for 10 seconds ...............................................................................................
The ProDigital™ will factory reset then provide 2 selectable mode options.
• Use the Left / Right keys to scroll between modes ...........................................
Mode 1 = Thermostat
Mode 2 = Time Clock
Note: the selected option will flash.
• Press the
key to confirm selection ........................................................................
The ProDigital™ will reset all parameters and restart in the selected mode.
Note: The Mode Select function will reset all parameters that were entered
during the set-up operations. These processes must be repeated after the
restart has completed.
To Next Page
Loading...
