18
System Requirements
To begin using an AP, you must have the following minimum requirements:
• A 10Base-T Ethernet or 100Base-TX Fast Ethernet switch or hub or cross-over Ethernet cable
• At least one of the following IEEE 802.11-compliant devices:
– An 802.11a, 802.11b, or 802.11b/g client device
• A computer that is connected to the same IP network as the AP and has one of the following Web browsers installed:
– Microsoft® Internet Explorer 6 with Service Pack 1 or later and patch Q323308
– Netscape® 7.1 or later
Response Time This is the maximum time, in seconds, that the AP should wait for the PXU module to
respond to a request. The range is 1-10 seconds; the default is 3 seconds.
Retransmission The maximum number of times an authentication request may be transmitted. The
range is 0 to 4, the default is 3.
Module Status The status of the PXU Profile
To Next Page
Loading...
