Proxim ORiNOCO AP-700 - Hardware Installation; Attach Cables

Installation and Initialization AP-700 User Guide
Hardware Installation
20
Hardware Installation
Perform the following procedures to install the AP hardware:
• Attach Cables
• Install the Security Cover (Optional)
• Mount the AP-700
• Power On the Unit
Attach Cables
Cabling without Power Over Ethernet (PoE)
1. Plug the barrel of the power cable from the power supply into the power jack (the left-most port in the back of the unit,
see figure).
2. Connect one end of an Ethernet cable (not supplied) to the unit’s LAN port (see figure). The other end of the cable
should not be connected to another device until after installation is complete:
NOTE:
AP-700 units using external antennas must be installed by a suitably trained professional installation
technician or by a qualified installation service.
NOTE:
Before installing and using this product, visit the Proxim Support site at http://support.proxim.com for
Regulatory Information.
NOTE:
Avant d’installer et d’utiliser ce produit, consultez le manuel Safety and Regulatory Compliance
Guide.
NOTA:
Prima dell’installazione e dell’utilizzo del prodotto, consultare il documento Safety and Regulatory
Compliance Guide (Guida per la sicurezza e la conformità alle normative).
ANMERKUNG:
Lesen Sie vor der Installation und Verwendung dieses Produkts die wichtigen Informationen im
Handbuch Safety and Regulatory Compliance Guide.
NOTA:
Antes de instalar y utilizar este producto, consulte el manual Safety and Regulatory Compliance
Guide (Manual de seguridad y cumplimiento de la normativa).
注記 :
この製品をインストールして使用する前に、
『 Safety and Regulatory Compliance Guide 』 .