57
3. Click Edit in the Channel Blacklist Table
4. Set Blacklist Status to Enable.
Figure 4-12 Channel Blacklist Table - Edit Screen
• Wireless Distribution System: A Wireless Distribution system can be used to establish point-to-point (i.e. wireless
backhaul) connections with other access points. See Wireless Distribution System (WDS) for configuration
information.
Dynamic Channel Selection (DCS)
Dynamic Channel Selection (DCS) addresses two major requirements in Optimal Channel Configuration. Principally it
enables the on-the-fly channel change without requiring a system reboot on conditions like RADAR
Detection/Configuration change of Channel. In addition to this it houses the functionality to Monitor the Channel Health in
the background and triggers ACS to perform an Auto Scan Function to select the channel with lowest interference and
dynamically switches to the new channel.
The DCS is triggered under the following conditions:
1. Dynamic channel change required (Radar Detection and Configuration change)
2. Poor Condition of the current operating channel
NOTE: If the AP finds all the channels are busy in a two hour period, DCS no longer changes channels automatically and
sends a trap message.
To Next Page
Loading...
