41
Network
The Network tab contains the following sub-tabs:
• IP Configuration
• DHCP Server
• DHCP Relay Agent
• Link Integrity
• SNTP (Simple Network Time Protocol)
IP Configuration
This tab is used to configure the internet (TCP/IP) settings for the access point.
These settings can be either entered manually (static IP address, subnet mask, and gateway IP address) or obtained
automatically (dynamic).The DNS Client functionality can also be configured, so that host names used for configuring the
access point can be resolved to their IP addresses.
Figure 4-3 IP Configuration
You can configure and view the following parameters within the IP Configuration sub-tab:
NOTE: You must reboot the AP in order for any changes to the Basic IP or DNS Client parameters to take effect.
Basic IP Parameters
• IP Address Assignment Type: Set this parameter to Dynamic to configure the Access Point as a Dynamic Host
Configuration Protocol (DHCP) client; the Access Point will obtain IP settings from a network DHCP server
automatically during boot-up. If you do not have a DHCP server or if you want to manually configure the Access
Point’s IP settings, set this parameter to Static.IP Address: The Access Point’s IP address. When IP Address
To Next Page
Loading...
