30
Figure 2-13 System Status Screen
The buttons on the left of the screen provide access to the monitoring and configuration options for the AP. See
Advanced Configuration to begin configuring the AP manually.
You can also exit the Web interface or reboot the AP using these buttons.
The Command Line Interface (CLI) also provides a method for monitoring and configuring the AP using Telnet or a
serial connection. For more information about monitoring and configuring the AP with the CLI, see Command Line
Interface (CLI).
Using the Setup Wizard
The first time you connect to an AP’s HTTP interface, the Setup Wizard launches automatically. The Setup Wizard
provides step-by-step instructions for how to configure the Access Point’s basic operating parameters, such as Network
Name, IP parameters, system parameters, and management passwords.
Figure 2-14 Setup Wizard
Setup Wizard Instructions
1. Click Setup Wizard to begin. The Setup Wizard supports the following navigation options:
To Next Page
Loading...
