237
Each ASCII character corresponds to two hexadecimal digits. See ASCII Character Chart for ASCII/Hexadecimal
correspondence.
VLAN/SSID Parameters
Other Parameters
IAPP Parameters
NOTE: These parameters configure the Inter Access Point Protocol (IAPP) for roaming. Leave these settings at their
default value unless a technical representative asks you to change them.
Wireless Multimedia Enhancements (WME)/Quality of Service (QoS) parameters
The Wireless Multimedia Enhancements commands enable and configure Wireless Multimedia Enhancement/Quality of
Service parameters. The following two commands are part of the Wireless Interface Properties table.
128-bit 26 characters (0 - F) 13 alphanumeric characters
152-bit 32 characters (0 - F) 16 alphanumeric characters
Name Type Value Access CLI Parameter
VLAN Group N/A R vlan
Status Integer enable
disable (default)
RW vlanstatus
Management ID VlanId -1 (untagged)
or 1 - 4094
RW vlanmgmtid
Name Type Value Access CLI Parameter
IAPP Group N/A R iapp
IAPP Status Integer enable (default)
disable
RW iappstatus
Periodic Announce
Interval (seconds)
Integer 80
120 (default)
160
200
RW iappannint
Announce Response
Time
Integer 2 seconds R iappannresp
Handover Time-out Integer 410 ms
512 ms (default)
614 ms
717 ms
819 ms
RW iapphandtout
Max. Handover
Retransmissions
Integer 1 - 4 (default 4) RW iapphandretx
Send Announce Request
on Startup
Integer enable (default)
disable
RW iappannreqstart
Key Length Hexadecimal ASCII
To Next Page
Loading...
