Proxim ORiNOCO AP-700 - Page 52

Advanced Configuration AP-700 User Guide
Interfaces
52
original power level to maintain a good link. For a full discussion of DFS, see Dynamic Frequency Selection/Radar
Detection (DFS/RD).
Configuring TX Power Control
1. Click Configure > Interfaces > Operational Mode.
2. Select Enable Transmit Power Control.
3. Enter the desired backoff from the maximum Transmit Power level (between 0 and 35 dBm) in the Wireless-A:
Transmit Power Level Back-Off field.
4. Click OK.