1. Introduction
Original Prusa i3 MK3S+ kit assembly 9
STEP 3 Use labels for reference
Most of the labels are scaled 1:1 and can be used to identify the part :-)
For the most common screws, nuts and PTFE tubes. You can also use the enclosed
letter, which contains Prusa Cheatsheet on the other side.
You can help.prusa3d.com/cheatsheet from our site. Print it at 100 %, don't rescale
it, otherwise, it won't work.
STEP 4 Spare bag
Every type of fastener is included in
a separate special bag.
If you lose a screw when building,
use one from this bag.
To Next Page