PSL PQube - Page 102

PQube User Manual 2.1
Page 102 of 113
[Power_Generation_Breakdown]
Solar_Power_Generation_In_Percent=1.00
Wind_Power_Generation_In_Percent=9.00
Coal_Power_Generation_In_Percent=0.00
Natural_Gas_Power_Generation_In_Percent=6
4.00
Hydro_Power_Generation_In_Percent=17.00
Diesel_Power_Generation_In_Percent=1.00
Nuclear_Power_Generation_In_Percent=8.00
Custom_Power_Generation_In_Percent=0.00
These values typical for California. Check with your
electricity provider to find typical values where
your PQube is installed.
[Trend_Settings]
Enable_Daily_Trends=ON
Enable_Weekly_Trends=ON
Enable_Monthly_Trends=ON
Daily Trends and Statistics are recorded every
midnight.
Weekly Trends and Statistics are recorded every
midnight between Sunday and Monday using ISO
8601 methods.
Monthly Trends and Statistics are recorded every
midnight after the last day of the month.
ON
OFF
Trend_Individual_Phases=ON
If OFF, your PQube records worst-case and average
of all phases. If ON, your PQube also records the
values of individual phases. This data is available
for Voltage, Current, and Power.
ON
OFF
Omit_Flagged_Mains_Voltages_From_Stats=OF
F
Disturbances on your power line can skew your
statistics, so you may opt to omit these values
when your PQube is processing statistics data.
ON
OFF
Unbalance_Component_To_Trend=NEGATIVE
Choose which unbalance component to trend.
Only applies if IEC or GB unbalance method is
selected.
NEGATIVE
ZERO