PSL PQube - Network Configuration Settings

PQube User Manual 2.1
Page 95 of 113
Trigger_Relay_On_Phase_Current= OFF
Trigger_Relay_On_Neutral_Current= OFF
Trigger_Relay_On_Earth_Current= OFF
Trigger_Relay_On_Probe_1_Undertemperature=OFF
Trigger_Relay_On_Probe_1_Overtemperature=OFF
Trigger_Relay_On_Probe_1_Low_Humidity=OFF
Trigger_Relay_On_Probe_1_High_Humidity=OFF
Trigger_Relay_On_Probe_2_Undertemperature=OFF
Trigger_Relay_On_Probe_2_Overtemperature=OFF
Trigger_Relay_On_Probe_2_Low_Humidity=OFF
Trigger_Relay_On_Probe_2_High_Humidity=OFF
Network Configuration
Setup.ini Tags
Comments
Valid Values
Example
[Network_Setup]
IP_Address_Method=Use_DHCP
If you are automatically assigned an IP address by
your network, use DHCP. If you are using a static
IP, use Fixed IP.
Use_DHCP
Use_Fixed_IP
Publish_IP_Address=ON
Specify whether you want your PQube’s emails to
include the IP address or not.
ON
OFF
Ethernet_Link_Speed_Duplex=AUTO
AUTO
10HALF
10FULL
100HALF
100FULL