PSL PQube - PQube Installation Guide; Quickstart Installation Steps

PQube User Manual 2.1
Page 11 of 113
Installation
Quickstart
Snap your PQube (and any plug-in modules) on to your DIN rail.
Don’t have an ETH1, XCT4 or CT4 plug-in module? Go to step 3.
a) ETH1 module? Connect your Ethernet cable.
b) XCT current interface module? Connect your current transformer to the screw terminals of your
XCT module.
c) CT4 current sense module? Pass your current carrying conductors through the CT openings.
(a) (b) (c)
Connect Earth and Mains wires to your PQube.