PQube User Manual 2.1
Page 13 of 113
Your PQube is recording power quality events on its SD card. If you have an XCT or a CT4, your PQube
is also measuring energy.
Edit your Setup.ini file on your SD card to set location, thresholds, transformer ratios, email access,
and other settings. See Appendix 2.
General Installation
Mount your PQube securely
Your PQube, and its optional modules, are designed to be mounted on an industry-standard 35mm
DIN rail as rack- or panel-mounted equipment.
The optional PS1 Power Supply module connects to the right side of your PQube. The optional
ETH1 Ethernet module and current sensing modules connect to the left side of your PQube.
Connect them to your PQube in any order that is convenient. Do not connect multiple current
sensing modules. Only connect one current sensing module, either a CT4 or XCT4.
In the United States and Canada, the equipment installation shall meet ANSI/NFPA 70, NEC, with
CSA C22.1, CEC, Part I or with both as appropriate. In other countries, follow all local installation
requirements and regulations.
Your PQube’s “enclosure”, as defined in UL/IEC 61010-1, is provided by the installation, and must
be evaluated in the end product.
To Next Page
Loading...