PSL PQube - Appendix 2: Setup File Guide; PQube Setup Configuration Tags

PQube User Manual 2.1
Page 78 of 113
Appendix 2 – Setup File Guide
PQube Setup
Setup.ini Tags
Comments
Valid Values
Example
[PQube_Information]
General Information about your PQube
PQube_ID="PSL PQube in PSL Cal Lab"
The unique identifier will appear on all output
information. Quotation marks (“) are required.
Any combination
of letters,
numbers, spaces
and special
characters up to
63 characters
Location_Name="PSL Calibration Lab"
Note_1="PSL PQube – General
Demonstrator"
Note_2="(Located in PSL Calibration Lab)"
Appears on all Event/Snapshot and Trends and
Statistics recordings. Quotation marks (“) are
required.
Any combination
of letters,
numbers, spaces
and special
characters up to
63 characters
Power_Configuration=AUTO
Set this tag to AUTO if you want your PQube to
automatically choose its Power Configuration
based on the voltage it finds on its input terminals
when it starts up. Alternatively, you can specify
exactly which power configuration you would like
your PQube to lock onto.
AUTO
Single_Phase_L1_N
Single_Phase_L1_L2
Split_Phase
Star
Wye
Delta