PSL PQube - Page 96

PQube User Manual 2.1
Page 96 of 113
GARP_Interval_In_Minutes=0
[Fixed_IP]
IP_Address=
IP_Mask=
IP_Gateway=
IP_DNS1=
IP_DNS2=
Enter your IP address information here. This
information is ignored if DHCP is selected.
Setup.ini Tags
Comments
Valid Values
Example
[Email_Server_Settings]
SMTP_Server=
SMTP_Server_Port=DEFAULT
POP_Server=
POP_Server_Port=DEFAULT
Enter your email server settings here. Outgoing
mail typically goes through SMTP servers, and
incoming mail typically comes through the POP
server.
PQube_Email_Address=
PQube_Email_User_Name=
PQube_Email_Password=
IMPORTANT: Your PQube needs its own e-mail
account. Do not try to share your personal e-mail
account with your PQube – if you do, it will try very
hard to receive all of your e-mails. You can get a free,
temporary PQube e-mail account from PSL. Contact
support@powerstandards.com
On_Failure_Retry_N_Times=3
Set how many times your PQube should try to
reconnect to your email server.
Any number
POP_Auth_Method=AUTO
AUTO
USER-PASS
PLAIN
LOGIN
DIGEST-MD5
CRAM-MD5
APOP