PSL PQube - Web Server Access and Commands; FTP Server Access and File Transfer

PQube User Manual 2.1
Page 64 of 113
Reset Analog Energy Accumulator
Resets accumulated Analog energy values.
Set Harmonic of Interest to #
Sets the Harmonic of Interest on the PQube display and Web
Server. Replace # with the desired harmonic order of interest
(1-50).
Web
In order to access your PQube’s web site, you will need set up the web server (see Web Server
Setup on page 35) and determine the IP address of your PQube. If you are using fixed IP, you
already know the IP address, but if you are using DHCP, you can find your IP address at the
Network screen. If you are on the same local network, enter the IP address into your browser.
You will be able to see the present status of your PQube, real-time meters, and all event, trend,
and statistics recordings stored on your PQube’s SD card. To restrict access to your web server,
you can specify a user name and password in your Setup.ini file.
You can perform the following actions under the Commands section:
 Generate Snapshot
 Generate Daily Trends
 Send Test E-mail
 Reset Energy Accumulators
 Reset Analog Energy Accumulator
 Reset Peak Measurements
 Reset PQube
 Upload new setup file
 Firmware Update
Access to these commands can be restricted by specifying an administrator username and
password in your Setup.ini file.
Under the Meters tab, you can view the total memory usage in your SD card. This value appears as
0% full after reset, and is updated every evening.
FTP
After you set up your PQube’s FTP server (see FTP Setup on page 35), you can access your PQube
using any standard FTP client, with the following restrictions:
 you must restrict your client to 1 simultaneous connection (consult your client’s
documentation for details on how to do this)