VP Keypad Access Device
24
114A3868.E rev. 7-2017
Time Format
12 Hour
Controls how the time is displayed. Options are 12 Hour and 24
Hour. The 12-hour displays the time as H H:M M:SS followed by am
or
pm. The hour will be displayed as 12:00:00 a m to 11:59:59
pm. The 24- hour format displays the time as H H:M M:SS without
the am or pm indicator. The hour will be displayed as
00:00:00 to
23:59:59. Factory default of 12-hour.
Max. #Attempts:00
(0-10,0=o):
Sets the maximum number of attempts within a one minute period
before the keypad prevents further code entry — e.g. if the
number is set to
3, then after three successive attempts with invalid
codes, the user will be locked out. The lockout will remain active
for 60 seconds after the last key press. If the user continues to press
keys the lockout time will continue to be reset.. The maximum
number of attempts is 10. Use 000 to disable the lockout feature.
The factory default is 000.
Presence In Req.
Disabled
Used where a vehicle sensor is installed in a drive or other traffic
area. When this feature is
Enabled, a presence must be detected
before a code or card can be used (usually by a loop in the ground
under the driveway). This feature can also be used with an alternate
alarm system. Factory default is Disabled
Card Format
26 Bit
Set the format of the cards being used for access — options are
26, 30, 31, and 34 Bits. See the card manufacturer specifications
to determine the Bits of the card. Factory default is 26 Bit.
To Next Page
Loading...