VP Keypad Access Device
25
rev. 7-2017 114A3868.E
Trip Relay NoCom
Disabled
After any code has been entered the display will read Access
Granted and the relay will be tripped to allow access. When
Enabled, the keypad will allow the relay to be triggered when the
communications are offline. Enabling this setting compromises
site security. Factory default is Disabled.
Com O Time:005
(1-25 sec):
Sets the amount of time the keypad should wait before deciding it
has lost communication with the controller. Any value from 1 to 25
seconds can be entered. Factory default is 5 seconds.
Setup Complete
Press # key
Message displayed when exiting setup mode. Pressing the # key
will return the device to normal operation. If no key is pressed, the
device will return to normal operation after a few seconds and all
information will be automatically saved.
To Next Page
Loading...