VP Keypad Access Device
4
114A3868.E rev. 7-2017
If the VP is installed on an exterior wall, seal the contact point
between the housing and the wall with a silicone sealant rated
for outdoor use. This prevents moisture and insects from getting
into the housing.
Gooseneck Stand Mount
A gooseneck is commonly used for driveways for vehicle access.
The gooseneck can also be used near doors for wheelchair access
or when sidewalks and landscaping require a freestanding keypad
mount away from the building.
• The base plate of a gooseneck has a hole that accepts conduit
(¾” maximum) for electrical wiring. Ensure the conduit is
placed properly and the wiring runs through the conduit before
mounting the gooseneck stand to the concrete base. The final
location of the gooseneck and the mounting techniques may
be affected by local building codes.
• As a precaution, the gooseneck should be protected with
concrete bollards to prevent vehicles from damaging the
electronics.
• There are several different styles of gooseneck stands available.
See for the dimensions of two common styles in “Drawing 3:
Gooseneck stand mount” on page 5.
Wall Mount Gooseneck
A wall mount gooseneck allows the
keypad to be mounted on a wall. It may
be used for door strikes or for gates in
driveways ajacent to a building wall, as
shown in “Drawing 6: Silicone seal for
gooseneck” on page 9.
The wallmount gooseneck also gives
wheelchair users access to a device.
Mounting height is generally 48” – 58”
Drawing 2: Wall mount
Gooseneck
To Next Page
Loading...