Pullmaster M50 - Page 39

PAGE 37
323 REV.030624
APPENDIX A
POUNDS
(KILONEWTONS)
DRUM
CODE
CABLE DRUM SIZES
INCHES
(MILLIMETERS)
WIRE ROPE STORAGE
FEET
(METERS)
FEET/MINUTE
(METERS/MINUTE)
LINE PULL
AT MAXIMUM
PRESSURE*
BARREL FLANGE LENGTH 1 1/4 inch 1 1/8 inch 1 inch
LINE SPEED
AT MAXIMUM
VOLUME*
BARE FULL BARE FULL
DRUM DRUM DRUM DRUM
M50-1 14.0 23.8 14.0 177 195 276 50000 33889 69 102
(356) (605) (356) (54) (60) (84) (222) (150) (21) (31)
M50-2 18.0 30.0 22.0 440 605 654 39610 26522 87 131
(457) (762) (559) (134) (184) (199) (176) (118) (27) (40)
M50-13 14.0 36.0 36.0 1503 1858 2221 50000 21942 69 158
(356) (914) (914) (458) (566) (677) (222) (98) (21) (48)
M50A-1 14.0 23.8 14.0 177 195 276 50000 31890 49 71
(356) (605) (356) (54) (60) (84) (222) (142) (15) (22)
M50A-2 18.0 30.0 22.0 440 605 654 39610 27320 62 91
(457) (762) (559) (134) (184) (199) (176) (122) (19) (28)
M50A-13 14.0 36.0 36.0 1503 1858 2221 50000 21951 49 113
(356) (914) (914) (458) (566) (677) (222) (98) (15) (34)
M50C-1 14.0 23.8 14.0 177 195 276 36281 24593 95 141
(356) (605) (356) (54) (60) (84) (161) (109) (29) (43)
M50C-2 18.0 30.0 22.0 440 605 654 28742 19247 120 181
(457) (762) (559) (134) (184) (199) (128) (86) (37) (55)
M50C-13 14.0 36.0 36.0 1503 1858 2221 36281 15929 95 216
(356) (914) (914) (458) (566) (677) (161) (71) (29) (66)
* Performance specifications are based on standard hydraulic motor with 1 1/4 inch diameter rope.
Consult factory for specifications of Model M50D.
30% OF MAXIMUM PERMISSIBLE LINE PULL
MAXIMUM
ALLOWABLE
LOAD FOR
CONTROLLED
OR
COMBINED
FREE FALL