EasyManua.ls Logo

Pulsar G10KBN - Operation; Generator Grounding Procedure; Starting Engine (Gasoline Operation); Starting Engine (LPG Operation)

Pulsar G10KBN
26 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
OPERATION




Generator must be properly grounded to prevent electrocution.
How to Start Engine (See fig 8-14 )
9
2lectric

CHOKE RUN
CHOKE LEVER
CHOKE RUN
CHOKE LEVER
W
AIT
5sec










Grounding the Generator (See fig 7)
START

START
MUST


9 )
  SKIP THIS IF THE ENGINE IS WARM OR HOT.
For electric start, Push and hold the engine START/ON/OFF switch in the “START” position. Do not hold the START/
2
START/




Connect the gas pipe to the intake nozzle of regulator ; Open the valve of LPG bottle 
  SKIP THIS IF THE ENGINE IS WARM OR HOT.
For electric start, Push and hold the engine START/ON/OFF switch in the “START” position. Do not hold the START/
ON/OFF switch in the “Start” position for more than 15 seconds. Allow 1 minute between starting attempts.
START/




2

Related product manuals