EasyManuals Logo

Pulsar G10KBN User Manual

Pulsar G10KBN
26 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #20 background imageLoading...
Page #20 background image
Used oil should be disposed of at an approved disposal site. See your local oil retailer for
more information.
CAUTION!
MAINTENANCE
20
Air Filter (See Fig 22)
Checking Spark Plug (See Fig 23)
Disconnect the spark plug wire from the spark plug.
Before removing the spark plug, clean the area around its base to prevent debris from entering the engine.
Clean carbon deposits off the electrode with a wire brush.
Check the electrode gap and slowly adjust to .700 mm - .80 mm (.028 - .031") if necessary.
Reinstall spark plug and tighten to Torque 22.0 – 26.9 Nm (16-20 ft-lb).
Reconnect spark plug wire.
If spark plug is worn replace only with an equivalent replacement part. Spark plug should be replaced annually.
(BOSCH F7TC, NGK BP6ES, CHAMPION N9YC or Equivalent)
To clean, remove the air filter cover.
Carefully pull the air filter out by lifting up along the edges.
Remove dirt from filter by tapping on it or having it blown out. Replace with new filter annually.
Reinstall air filter so that it seals and replace air filter cover.
A dirty air filter will reduce the life span of the engine, make it difficult to start the engine, and reduce the unit’s performance.
Fig 23
.700-.800mm
Fig 22

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Pulsar G10KBN and is the answer not in the manual?

Pulsar G10KBN Specifications

General IconGeneral
BrandPulsar
ModelG10KBN
CategoryPortable Generator
LanguageEnglish

Related product manuals