9
Starting The Generator
With the engine started, make sure the Multi-Switch
is in the ‘RUN’ position, then set the “Low Idle” rocker
switch to your load-based preference.
Hot Restart on Propane - Special Note
When both gasoline and propane are present in the generator it
is recommended to start the generator on gasoline first, allow
the engine to stabilize then switch to propane.
Fuel source rocker switch to ‘GASOLINE’
Pull cord to start the engine, wait for the green light
OPEN the LPG valve completely
Fuel source switch to ‘LPG’
FUEL SOURCECIRCUIT BREAKERINDICATOR LIGHTLOW IDLE
PARALLEL CONNECTION
TO AVOID DAMAGE, DO NOT CONNECT OR DISCONNECT PARALLEL CABLES WHILE THE UNIT IS RUNNING.
SELECTOR SWITCH
STEP 2. Let the recoil handle retract completely.
STEP 3. Grasp the top handle securely and pull the recoil
handle swiftly and completely; the engine should start.
CLOSED
OPEN
Ensure the LPG supply hose is securely attached and
Close the LPG valve completely
FUEL SOURCE
FUEL SOURCE
FUEL SOURCECIRCUIT BREAKERINDICATOR LIGHTLOW IDLE
PARALLEL CONNECTION
TO AVOID DAMAGE, DO NOT CONNECT OR DISCONNECT PARALLEL CABLES WHILE THE UNIT IS RUNNING.
SELECTOR SWITCH
To Next Page
Loading...
