EasyManuals Logo

Pulsar PG10000B Owner's Manual

Pulsar PG10000B
43 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #17 background imageLoading...
Page #17 background image
Operation (cont’d)
17
3. If the engine is cold: Pull the choke lever out to close the choke.
4. Continue to desired start-up method.
RECOIL START METHOD
2. Press the engine switch to the "ON" position.
1. Disconnect all devices from the outlets on the generator panel.
3. Grasp the recoil starter handle and pull it until the engine starts.
Do not allow the recoil starter to snap back. Return it slowly by hand
2. Rotate the fuel valve lever to ON position.
4. Push the choke lever to the OPEN position as the engine warms up. The
choke is used to provide the proper mixture when the engine is cold.
It can be opened and closed by operating the choke lever manually by
starting.
ELECTRIC STARTING METHOD
Batteries produce explosive gases. Keep sparks, flames and cigarettes away
from the battery. To prevent the possibility creating sparks near the battery,
connect the charging cables to the battery terminals first, then to the generator.
When disconnecting, remove cables at generator first.
1. Follow fuel source selection steps.
2. Push the engine ignition button until the generator starts. Do not push

Other manuals for Pulsar PG10000B

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Pulsar PG10000B and is the answer not in the manual?

Pulsar PG10000B Specifications

General IconGeneral
BrandPulsar
ModelPG10000B
CategoryPortable Generator
LanguageEnglish

Related product manuals