EasyManua.ls Logo

Pulsar PG6580E - Adding and Checking Engine Oil

Pulsar PG6580E
50 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Antidotes for battery acid
CONTACT TREATMENT
External Flush with water.
Internal Drink large quantities of milk or water, followed by milk of
magnesia, vegetable oil or beaten eggs. Get immediate
medical attention.
12
ASSEMBLY
Place generator on a level surface.
Insert a funnel into the dipstick hold and carefully add engine oil (SAE10W- 30) to empty reservoir
until oil reaches the threads of the oil fill hole.
Be sure to replace dipstick before attempting to start the engine.
To check oil, set generator on a level surface, wipe dipstick clean, reinsert dipstick without rethreading; remove and
read level.
Adding / Checking Engine Oil (See fig 4)
Eyes Flush with water. Get immediate medical attention.
You must add oil before first operating this generator. Always check oil level before each
operation.
DO NOT USE E85 FUEL IN THIS UNIT. IT IS A VIOLATION OF FEDERAL LAW AND
WILL DAMAGE THE UNIT AND VOID YOUR WARRANTY.
CAUTION!
Fig 4
10W30 OIL

Related product manuals