PuraTech
®
Owner’s Manual 12/11/2013 7
Customer Settings
Service Settings must be set before Customer Settings; Service Settings should be set during installation of the
appliance.
To set Customer Settings, press and hold the Display button for about five seconds while “Customer Setting”
displays. Release the button when “Set Time” displays. If the setting displayed is correct, press Display to move
to the next setting. If metric units are selected when the Service Settings are set, the time of day and
regeneration time will be based on a 24-hour clock.
Display reads “Set Time” followed by the current time that is set; the cursor will be under the
second hours digit.
To Change the Time of Day
A. Press Change repeatedly until the current hour is displayed.
B. Press Select to set the hour and move the cursor to the right.
C. Do the same to set the minutes. Select AM or PM. When the desired time is displayed,
press Display to step to the next parameter.
Note: Whenever you experience an electrical outage, check the controller for the correct time.
Make any necessary corrections.
Display reads “Reg. Time” followed by the current regeneration time that is set; the cursor will be
under the second hours digit. Usually you want to set a regeneration time when water will not be
used.
To Change the Regeneration Time
A. Follow the procedure outlined above for setting the time.
B. When the desired regeneration time is displayed, press Display.
Display reads “# People” followed by the current setting for the number of people in the
household; the cursor will be under the tens digit.
To Change the Number of People
A. Press Change repeatedly until the desired value is displayed; values will cycle from 0 to 9.
B. Press Select and the cursor moves to the right.
C. When the desired number of people is displayed, press Display to exit the Customer Setting
mode.
When you press the Display button at “# People,” the values are saved, and the controller
returns to normal operating mode.
To Next Page
Loading...
