PWB TOOL MASTER Lite 14 User Manual

TOOL MASTER Lite 14 10 MANUAL © Evoset AG
Z-Axis Reference
1. Select Absolute Mode by pressing the ABS/REL key. The display should read ABS.
2. Make sure that the Main Origin is active. The display should read ORG with no number (0
through 3) next to it.
If a different origin is active, press SET and hold it while pressing ABS/REL until the Main
Origin is active.
3. Release the Z-axis Locking Knob and position the Probe in contact with the Tool Pot surface,
as shown below.
4. Press the SET key and hold while pressing the CLEAR Key. The display shows the
calibrating value, similar to the engraving on the tool pot. Z-axis is now referenced.

PWB TOOL MASTER Lite 14 Specifications

General

Brand	PWB
Model	TOOL MASTER Lite 14
Category	Industrial Equipment
Language	English