TOOL MASTER Lite 14
18
MANUAL © Evoset AG
9. Maintenance
Cleaning
The pre-setter does not require particular cleaning. Occasionally clean the Guide Rails with a
brush and a clean cloth. Avoid environments with high concentrations of dust or humidity as
recommended in this manual.
Lubrication
Apply a thin coat of spray lubricant to the X-axis Guide Rail to prevent oxidation. Do not use
grease lubricants. If the pre-setter is not going to be used, remove the Tool Sleeve and spray
with lubricant to prevent rusting. Spray the Flange and X-Axis Guide Rail as well.
Battery Replacement
All data is stored in the event the battery is removed or needs to be replaced. After installing a
new battery, perform the X and Z-axis reference as shown in this manual.
(One AA Battery)
(Two AA Batteries)
To Next Page