PWB TOOL MASTER Lite 14 - Control Description

TOOL MASTER Lite 14 6 MANUAL © Evoset AG
4. Control description
Control Key Function
ENTER
• Confirm selection
SET
•
Access programming menu by pressing and holding for 5 sec.
• Reset X-Axis origin by holding and pressing CLEAR
• Reset Z-Axis origin by holding and pressing CLEAR
• Toggle between ORG origins by holding and pressing
ABS/REL (Absolute Mode)
• Toggle between CNT origins by holding and pressing
ABS/REL (Relative Mode)
•
Navigate through programming menu
ABS/REL
• Toggle between Absolute and Relative Measurement Mode
• Navigate through programming menu
CLEAR
• Clear Measurement to zero (Relative Mode only)
• Toggle between options in programming menu