Pyle IP Cam Mobile App Setup Instructions
Find FAQs including setup video and support online at
http://www.pipcamwireless.com
This Guide covers the following models
-PIPCAM5
-PIPCAM12
-PIPCAM15
Before you begin…
Setup should be done in the same room as the wireless router in your home.
Note: All links in the document can be found in the support section at
www.pipcamwireless.com using search.
Prepare the camera
1) Plug your camera into power
2) Attach the wireless antenna to your camera (If applicable)
3) Plug your camera directly into your router with wired Ethernet wire
4) Wait 2-3 minutes for camera to boot
-Wait 2-3 minutes for camera to boot. You will see the camera run through a full
range of pan and tilt motion.
-When boot up completes, your camera's Ethernet port will show a solid green
To Next Page
Loading...
Need help?
General