Page: 10
H. SMS Commands
If you have purchased the GPRS version of Enforcer, it will allow you to send SMS commands via a mobile phone, allowing you to arm/disarm the panel
remotely along with several other commands (see below the different SMS commands available).
NOTE: Any text message command to the Enforcer will need to start with a valid user code.
NOTE: Text messages commands are not case sensitive except when the used outputs are activated.
NOTE: If a text messages commands is not recognised by Enforcer it will send back to the user the wrong command.
Arming via SMS text command
Example SMS command send: Description: Example SMS command response:
123456 Arm A 123456 = User Code. Arm A = Will arm the
Enforcer in Area A.
Final Arm; Area A
123456 Arm ABCD 123456 = User Code. Arm ABCD = Will arm the
Enforcer in Area ABCD.
Final Arm; Area ABCD
NOTE: If no areas are specified then all areas will arm (default). In ‘One Area’ Mode, the default will be Area A.
Disarming via SMS text command
Example SMS command send: Description: Example SMS command response:
123456 Disarm A 123456 = User Code. Disarm A = Will disarm
Area A.
Disarm; Area A
123456 Disarm ABCD 123456 = User Code. Disarm ABCD = Will disarm
the Area ABCD.
Disarm; Area ABCD
NOTE: If no areas are specified then all areas will disarm (default). In ‘One Area’ mode, the default will be Area A.
Arming with inputs bypassed via SMS text command
Example SMS command send: Description: Example SMS command response:
123456 Arm A Bypass 4 123456 = User Code. Arm A Bypass 4 = Arms
Area A and will bypass input number 4.
Input Bypass; Area A Input 04
Force Arm: Area A
123456 Arm A Bypass Kitchen 123456 = User Code. Arm A Bypass Kitchen =
Arms Area A and will bypass the input that is
called Kitchen.
Input Bypass; Area A Kitchen
Force Arm: Area A
Bypassing inputs via SMS text command
Example SMS command send: Description: Example SMS command response:
123456 Bypass 6 123456 = User Code. Bypass 6 = In the next
arming procedure, input number 6 will be
bypassed.
Input Bypass; Area A Input 06
123456 Bypass Garage 123456 = User Code. Bypass Garage = In the
next arming procedure, the input called Garage
will be bypassed.
Input Bypass; Area A Garage
NOTE: The name of the output has to be one word and spelled exactly as written in the panel (verbatim). For example, Garage Door is not
acceptable. It has to be written as Garage-Door in the panel and the respective command will be Garage-Door.
To Next Page
Loading...
Need help?
General
